Garbage Disposal Installation

Garbage disposal can be easy to to install in getz handyman garbage disposal installation in las vegas will cost u 120$ flat fee

if u want to try do it yourself u can follow the next steps.

Cut power to the outlet your disposal will use.

Uninstall the existing disposal, clean old putty from the area before putting in the new unit.

disconnected the drain line

Remove the old putty from the sink opening.

Turn over the mounting assembly.

loses all the mounting screws to access the snap ring.

snap ring from the sink flange and separate the parts as the mounting assembly comes apart.

Apply putty around the sink opening .
Put the mounting ring against the backup ring as you hold the fiber gasket in place.

Slide the snap ring up the flange until you hear it pop in place.

Tighten the mounting screws to hold the entire assembly in place against the sink.

Knock out the plug and turn the unit on its side.

with flathead screwdriver push against the plug and allow it to go down the unit.

Turn the disposal upright to remove the gasket and the ring.

Turn the disposal upside down again to get the plug.

Then turn the disposal upright again to replace the gasket and ring.

Find the electrical hole to insert a wire clamp.

make sure that there is no power to the garbage disposal.

Remove the screw holding the access hole cover to be able to pull out the wires.

Connect the wires black-to-black and white-to-white.
Make sure that the wires are secure before the ground wire.

Lift the unit into place and insert the top end of the mounting gasket into the assembly.

Turn the lower mounting ring clockwise until the mounting tabs are snugly in place.

Lock the tabs over the ridges with the use of a pair of adjustable pliers.

Attach the P-trap to the trap arm and the tailpiece.

The discharge tube should go into the T-fitting, but do not tighten the slip nut completely.

The other end of the discharge tube should go into the disposal system.

Take a screwdriver to secure the metal flange and tighten the slip nuts.

The bell should go over the disposal drain and clamped in place.

Run water through to check for leaks in the system.

congrats u just finished your installation

it is always best to call Getz handyman if u are not sure in the process